Dfi CM100-C Manuel d'utilisateur télécharger pdf (Page 64)

www.dﬁ .com

Appendix C System Error Message

Appendix C

Appendix C - System Error Message

When the BIOS encounters an error that requires the user to correct something, either a beep

code will sound or a message will be displayed in a box in the middle of the screen and the

message, PRESS F1 TO CONTINUE, CTRL-ALT-ESC or DEL TO ENTER SETUP, will be shown in

the information box at the bottom. Enter Setup to correct the error.

Error Messages

One or more of the following messages may be displayed if the BIOS detects an error during

the POST. This list indicates the error messages for all Awards BIOSes:

CMOS BATTERY HAS FAILED

The CMOS battery is no longer functional. It should be replaced.

CMOS CHECKSUM ERROR

Checksum of CMOS is incorrect. This can indicate that CMOS has become corrupt. This error

may have been caused by a weak battery. Check the battery and replace if necessary.

DISPLAY SWITCH IS SET INCORRECTLY

The display switch on the motherboard can be set to either monochrome or color. This indi-

cates the switch is set to a different setting than indicated in Setup. Determine which setting

is correct, either turn off the system and change the jumper or enter Setup and change the

VIDEO selection.

FLOPPY DISK(S) fail (80)

Unable to reset floppy subsystem.

FLOPPY DISK(S) fail (40)

Floppy type mismatch.

Hard Disk(s) fail (80)

HDD reset failed.

Hard Disk(s) fail (40)

HDD controller diagnostics failed.

Hard Disk(s) fail (20)

HDD initialization error.

Hard Disk(s) fail (10)

Unable to recalibrate fixed disk.

Hard Disk(s) fail (08)

Sector Verify failed.

Keyboard is locked out - Unlock the key

The BIOS detects that the keyboard is locked. Keyboard controller is pulled low.

Keyboard error or no keyboard present

Cannot initialize the keyboard. Make sure the keyboard is attached correctly and no keys are

being pressed during the boot.

Manufacturing POST loop

System will repeat POST procedure infinitely while the keyboard controller is pull low. This is

also used for the M/B burn in test at the factory.

BIOS ROM checksum error - System halted

The checksum of ROM address F0000H-FFFFFH is bad.

Memory test fail

The BIOS reports memory test fail if the memory has error(s).

Important:

Danger of explosion if battery incorrectly replaced. Replace only with the same or

equivalent type recommended by the manufacturer. Dispose of used batteries accord-

ing to the battery manufacturer’s instructions.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 70

Commentaires sur ces manuels

Pas de commentaire

Dfi CM100-C Manuel d'utilisateur Page 64

Commentaires sur ces manuels

Produits connexes et manuels pour Carte mère Dfi CM100-C