rev. A+
45411042
Clear CMOS Data - JP7
1-2 On: Normal (default)
2-3 On: Clear CMOS Data
Before clearing the CMOS data,
make sure to power-off your system
and unplug the power cord.
PCI Standby Power LED
This LED will turn red when the
system is in the power-on, Soft-Off
or Suspend mode. It serves as a
reminder that you must power-off
the system then turn off the
power supplys switch or unplug
the power cord prior to installing
any add-in cards.
The frequency ratio of some
processors shown in the table may
have been locked by the
manufacturer. If you are using this
kind of processor, setting an
extended ratio for the processor
will have no effect. The system will
instead use its factory default ratio.
The frequency ratio of processors
greater than 8x has been locked by the manufacturer and will no longer have the flexibility of using
extended ratios. Therefore, the system will use the processors factory default ratio.
The voltage regulator will automatically be set according to the voltage of the processor.
At the time this
document was printed,
the CPU marked with
asterisk (
*
) is not yet
available. It is included in
the table for reference
only.
The 5VSB power source
of your power supply
must support a
minimum of ≥720mA.
JP3
1-2 On
2-3 On
2-3 On
All Off
JP4
1-2 On
2-3 On
All Off
All Off
Auto*
66MHz
100MHz
133MHz
CPU FSB Select - JP3 and JP4
* denotes default
Frequency Ratio Settings for Processors
--- --- 4x
-- - 4.5x
333MHz 5x
Processor
SW1
66MHz 100MHz
Freq.
Ratio
5.5x
Processor
SW1
66MHz
100MHz
Freq.
Ratio
400MHz
433MHz
466MHz
500MHz
6x
6.5x
7x
7.5x
8x533MHz
500MHz
366MHz
133MHz
533MHz
133MHz
650MHz
700MHz 933MHz
866MHz
800MHz
750MHz
1GHz
800MHz
1.066GHz*
667MHz
733MHz
300MHz
300AMHz
550MHz
600MHz
600MHz
CA63-EN
Commentaires sur ces manuels