DFI G7V600-B Manuel d'utilisateur télécharger pdf (Page 49)

Hardware Installation

IrDA Connector

Connect your IrDA cable to connector J5 on the system board.

Note:

The sequence of the pin functions on some IrDA cable may be

reversed from the pin function defined on the system board.

Make sure to connect the cable to the IrDA connector

according to their pin functions.

BIOS Setting

Configure the onboard IrDA in the Integrated Peripherals submenu

(“Super I/O Device” section) of the BIOS to the type of IrDA

standard supported by your device.

Driver Installation

You may need to install the proper drivers in your operating system

to use the IrDA function. Refer to your operating system’s manual or

documentation for more information.

VCC

N. C.

IRRX

Ground

IRTX

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 121 122

Pas de commentaire

DFI G7V600-B Manuel d'utilisateur Page 49