Dfi CR902-B Manuel d'utilisateur télécharger pdf (Page 12)

www.dﬁ .comChapter 3 Hardware Installation

Chapter 3

System Memory

DDR3_2

Standby

Power LED

The system board is equipped with two 204-pin SODIMM sockets that support DDR3(1.5V)/

DDR3L(1.35V) memory modules; depends on CPU supported. However, DDR3L memory mod-

ule can run at 1.5V.

DDR3_1

Important:

Electrostatic discharge (ESD) can damage your board, processor, disk drives, add-in

boards, and other components. Perform installation procedures at an ESD workstation

only. If such a station is not available, you can provide some ESD protection by wear-

ing an antistatic wrist strap and attaching it to a metal part of the system chassis. If

a wrist strap is unavailable, establish and maintain contact with the system chassis

throughout any procedures requiring ESD protection.

Important:

When the Standby Power LED lit red, it indicates that there is power on the board.

Power-off the PC then unplug the power cord prior to installing any devices. Failure to

do so will cause severe damage to the board and components.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 74 75

Pas de commentaire

Dfi CR902-B Manuel d'utilisateur Page 12