Dfi BT160 Manuel d'utilisateur télécharger pdf (Page 13)

www.dﬁ .com

Chapter 2 Hardware Installation

Chapter 2

Jumper Settings

Clear CMOS Data

If you encounter that CMOS data becomes corrupted, you can reconfigure the system with the

default values stored in the ROM BIOS.

To load the default values stored in the ROM BIOS, please follow the steps below.

1. Power-off the system and unplug the power cord.

2. Set JP8 pins 2 and 3 to On. Wait for a few seconds and set JP8 back to its default setting,

pins 1 and 2 On.

3. Now plug the power cord and power-on the system.

2-3 On:

Clear CMOS Data

1-2 On:

Normal (default)

JP8

Auto Power-on Select

1-2 On:

Power-on via power button

(default)

2-3 On:

Power-on via AC power

JP12 is used to select the method of powering on the system. If you want the system to

power-on whenever AC power comes in, set JP12 pins 2 and 3 to On. If you want to use the

power button, set pins 1 and 2 to On.

When using the JP12 “Power On” feature to power the system back on after a power failure

occurs, the system may not power on if the power lost is resumed within 5 seconds (power

flicker).

Note:

In order to ensure that power is resumed after a power failure that re covers within a

5 second period, set JP12 to 2-3 On and the “Restore AC Power Loss” in CMOS is set

to “Power On”.

JP12

132

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 70 71

Pas de commentaire

Dfi BT160 Manuel d'utilisateur Page 13