Dfi BT160 Manuel d'utilisateur télécharger pdf (Page 21)

www.dﬁ .com

Chapter 2 Hardware Installation

Chapter 2

Rear Panel I/O Ports

The rear panel I/O ports consist of the following:

• 1 12V DC-in jack (default) or 4-pin power connector (optional) - BT161

• 1 Serial COM port

• 1 VGA port

• 2 RJ45 LAN ports

• 1 USB 2.0 port

• 1 USB 3.0 port

LAN 1

LAN 2

DC-in

USB 3.0

12V DC-in (default) - BT161

DC-in

This jack provides maximum of 100W power and is considered a low power solution. Connect

a DC power cord to this jack. Use a power adapter with 12V DC output voltage. Using a volt-

age higher than the recommended one may fail to boot the system or cause damage to the

system board.

The 12V DC-in jack on the system board co-lays with a 4-pin power connector (optional) as

the figure displayed below.

DC-in jack

4-pin Power

COM 1

VGA

USB 2.0

Ground

+12V

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 70 71

Pas de commentaire

Dfi BT160 Manuel d'utilisateur Page 21