Dfi BT160 Manuel d'utilisateur télécharger pdf (Page 11)

www.dﬁ .com

Chapter 2 Hardware Installation

Chapter 2

Installing the DIMM Module

1. Make sure the PC and all other peripheral devices connected to it has been powered down.

2. Disconnect all power cords and cables.

3. Locate the SODIMM socket on the system board.

4. Note the key on the socket. The key ensures the module can be plugged into the socket in

only one direction.

Note:

The system board used in the following illustrations may not resemble the actual

board. These illustrations are for reference only.

6. Push down the module until the clips at each end of the socket lock into position. You will

hear a distinctive “click”, indicating the module is correctly locked into position.

Clip

5. Grasping the module by its edges, align the module into the socket at an approximately 30

degrees angle. Apply firm even pressure to each end of the module until it slips down into

the socket. The contact fingers on the edge of the module will almost completely disappear

inside the socket.

Clip

Important:

When installing one DDR3L SODIMM only, make sure to install it into the SODIMM 1

socket.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 70 71

Pas de commentaire

Dfi BT160 Manuel d'utilisateur Page 11