Dfi BT160 Manuel d'utilisateur télécharger pdf (Page 31)

www.dﬁ .com

Chapter 2 Hardware Installation

Chapter 2

Battery

Standby Power LED

This LED will light red when the system is in the standby mode. It indicates that there is pow-

er on the system board. Power-off the PC and then unplug the power cord prior to installing

any devices. Failure to do so will cause severe damage to the motherboard and components.

Standby Power LED

The lithium ion battery powers the real-time clock and CMOS memory. It is an auxiliary source

of power when the main power is shut off.

Safety Measures

• Danger of explosion if battery incorrectly replaced.

• Replace only with the same or equivalent type recommend by the manufacturer.

• Dispose of used batteries according to local ordinance

Connect to the

battery connector

Battery

+3.3V

GND

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 70 71

Pas de commentaire

Dfi BT160 Manuel d'utilisateur Page 31